I’ve had a MK4S for over a week now, and 100% of the prints I’ve tried to make on the textured sheets have partially or totally failed. PLA prints beautifully on the smooth sheet, but PLA, PETG and ABS, I think I could print on the surface of a 10 inch tank of oil with more success than the textured sheet. Plastic doesn’t stick to it. I’ve wiped it with isopopyl, I’ve washed it with dawn…it’s a bad print surface and I want my money back.
I had issues with mine, nothing was sticking to it causing 100% failures. I forgot where I read it but I ended up scrubbing it good with one of those slightly abrasive green pads in warm dawn dish soap, drying it with a clean microfiber cloth and putting it on the bed with the heat set to 60c for a few minutes. It now works extremely well with pla or petg, I just wipe it down with a bit of 90% alcohol between prints. Never had any issues with the smooth and satin sheets.