It’d gotten bad enough that I couldn’t reliably transfer data over usb. Now the cable fits snugly again
I just used a small sewing needle to pry out the lint. I tried using a toothpick at first, but it was too big to reach the bottom.
It’d gotten bad enough that I couldn’t reliably transfer data over usb. Now the cable fits snugly again
I just used a small sewing needle to pry out the lint. I tried using a toothpick at first, but it was too big to reach the bottom.
I should probably try that next time. What material did you use?
PLA but those should work fine with almost anything.